Model No:Intelligent 3D Pen. IV
Applicable material:PLA(1.75mm ± 0.02mm)
How to use DIKI 3D Printing Pen
Connect the power supply and the red LED light is on.
Click the button, then the red light is flashing and the preheating is beginning.
Wait for 30s, the red light turns green, then the preheating is finished.
Feeding the filaments:
Insert the filament into the “Wire feeding hole”.
Click the button, then the filament will be loading automatically.
Just waiting for the melted material is extruding, you can start drawing.
One click continuously extruding:
Click button once, the facility is extruding automatically.
Click again, the facility is paused.
The facility will stop every 8 minutes when continuously extruding.
Long press extruding:
Click the button twice swiftly and press the button all long then the facility is extruding.
When loose the button, the facility is paused.
Replace/ retreat the filaments:
When the right is green, press the button for 3 seconds,it will retreat automatically.
When the facility stop retreat, take it out from the “Wire feeding hole”.
Click the button, the motor stop working.
When you finished drawing, please retreat the filament.
In operation or within a short time after stop using, do not touch the tip or surrounding area.
Please warn the other around the operator do not touch the pen due to hazard heating.
The device is suitable for children over 8 years old and adults.
Do not use the pen near showers, basins or other places wet with water!!
2*Filaments(The colors of filament will be random shipments.)